Wing Root and Belly panels

The belly panels have been fabricated and glassed with two layers of bid.  Similar to the top root fairing panels two layers of poster board were attached, then covered in packing tape and duct tape as release agent prior to the fiberglass.  The fiberglass is yet to be removed so the poster board can be removed underneath.  Panels will be trimmed and attached.

The Leading edge cuff of the wing root fairings has also been completed with 2 bid.  These wing root fairings will all require some fill to get them nice and smooth.

Throttle Quadrant

My throttle quadrant set up has been modified to my particular needs.  The Throttle lever also has a lower reversing arm that can drive a throttle on the passenger side of the cockpit.  Mixture and prop will only be on the pilot side.  The passenger throttle will not be installed but will be available if required for X-training purposes.

First engine fitting.

Engine mounted for the first time.  Will test all attachment cables and firewall pass through items for connection to engine.

Wing Root fairings - upper

Began to build wing root fairings for the upper portion of wing.  I was looking for a way to do this that would not take to much time and effort as it would if foam were to be carved for shaping this section.  I used small 4 inch sections of double poster board to form the shape.  This worked well but I will have some filling to do on the upper surface due to stepping of each posterboard section onto the next.

Upper surfaces glassed with two layers of cloth.

Fuel lines at Wing Root.

Fabricated two fuel lines from wing tanks to fuselage where they connect to the fuel valve, filter and fuel flow sensor.

Elevators, Ailerons and Flaps

Built up the ailerons elevators and flaps as per plans.  Fabricated hinges for a Slotted Flaps, no photos.

Installed a servo for the elevator inside of the skin of the elevator.

Instrument Panel - Fabricate fiberglass support structure

Built up the instrument panel from 7 layers of bid fiberglass.